emonTx3 User Guide

• Overview
• Install Guide
  • Example emonTx sensor node installation
  • Installation overview
  • Temperature sensing
  • Pulse counting
• Adding to an existing install
  • 1. Adding one emonTx to an emonPi system
  • 2. Adding more than one emonTx to an emonPi or emonBase system
• 3-Phase
  • 1. Installation
  • 2. Emoncms Input processing
• Add ESP8266 WiFi
  • To set up an emonTx v3 + ESP8266 Wifi energy monitor you will need:
  • ESP8266 Huzzah WIFI module with a 6 way stackable header:
  • Setup procedure
  • EmonESP
  • MQTT
• Direct Serial
  • Using a USB to UART cable
  • Direct Raspberry Pi GPIO
• Configuration
  • DIP Switch
  • Serial Configuration
• Firmware
  • Available Firmware
  • Updating firmware using an emonPi/emonBase
  • How to compile and upload firmware
• Technical
  • Electrical characteristics
  • Port Map
  • Schematic and Board files
  • CT Sensor Burden Resistor Calculations
  • Power Supply Options
  • AC adapter voltage sensing and power supply.
  • Power supply design considerations
  • Enclosure